Wind River Spas TORNADO Spécifications télécharger pdf (Page 44)

5-4 20751-12 Rev.5

Netezza ODBC, JDBC and OLE DB Installation and Configuration Guide

Data Source Configuration Procedure

The following outlines the procedure to configure a Netezza appliance data source.

Note: This procedure is for configuring a 32-bit DSN on a 32-bit system or a 64-bit DSN on

a 64-bit system. 32-bit DSNs do not display in the 64-bit administrator. On a 64-bit sys-

tem, launch the administrator using the following: C:\windows\syswow64\odbcad32.exe

1. Open the ODBC Data Source Administrator Window and select either the System DSN

tab or the User DSN tab for the appropriate configuration. Then select either of the

following:

 To configure an existing DSN, select the Configure button.

 To configure a new DSN, select the Add button.

2. Configure the DSN and Driver Options from the Driver Setup Window.

3. Test and verify the ODBC Connection.

4. Close any open configuration windows to finish the Data Source Configuration.

ODBC Data Source Administrator Window The ODBC Data Source Administrator window

allows you to make configuration selections.

1. Select Start > Settings > Control Panel > Administrative Tools > Data Sources (ODBC).

The ODBC Data Source Administrator window is displayed, as shown in Figure 5-1:

Figure 5-1: ODBC Data Source Administrator Window.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 77 78

Pas de commentaire

Wind River Spas TORNADO Spécifications Page 44